Gas and safety · Published 2026-11-15 · Updated 2026-11-15
Boiler not working? What to check before calling an engineer
When the boiler stops, it is usually cold, it is usually inconvenient and you want to know whether it is a quick fix or a call out. This guide lists the safe checks that anyone can do, the point at which you must stop, and what to do in a gas emergency.
Quick answer. Check the power, thermostat and, on a prepayment meter, your credit. Look at the pressure gauge, which should usually sit between 1 and 2 bar, and try a reset following your manual. If it still fails, call a Gas Safe registered engineer. If you smell gas, call 0800 111 999 and do not touch switches.
What should I check first?
Your boiler needs gas, electricity and the right settings. Most guides from UK boiler makers and energy firms begin with the basics, because a surprising number of breakdowns are simple.
- Is the boiler display on? If it is blank, check whether other sockets in the house work, and look at the fuse board for a tripped switch.
- Is the thermostat set above the room temperature and the programmer on? Replace the batteries if the thermostat display is blank.
- If you pay by prepayment meter, make sure you have credit, including emergency credit.
- Test another gas appliance, such as the hob, to see whether the gas supply is on.
- Look for an error code on the display and check what it means in your manual.
What if the pressure is low?
Combination boilers rely on water pressure in the sealed heating system. Many guides say normal pressure is around 1 to 2 bar, which is often shown as the green zone on the dial. If the needle sits below 1 bar the boiler may lock out.
Your manual will show how to top the pressure up using the filling loop, which is a flexible hose or lever under the boiler. Do it slowly and watch the gauge. If the pressure keeps dropping, there may be a leak and you need an engineer. Do not keep topping it up week after week.
Is it safe to reset the boiler?
Many boilers have a reset button on the outside. Press it as your manual describes. British Gas notes that if the reset is inside the boiler casing, you should leave it to a Gas Safe engineer. Corgi Homeplan says that if you find yourself resetting often, the boiler should be checked.
One reset is reasonable. Repeated resets to keep the boiler running are not, because the boiler is shutting down for a reason.
What about the pilot light?
Some older boilers have a pilot light. If it has gone out, your manual will show how to relight it. If you cannot see a flame or it keeps going out, call an engineer, because a pilot that repeatedly fails points to a fault.
What must I never do?
Never take the casing off or alter the boiler. Worcester Bosch warns that fixing a boiler yourself can be dangerous and may invalidate your guarantee. All gas work must be done by a Gas Safe registered engineer.
If you smell gas, or you think you may have a carbon monoxide problem, treat it as an emergency. Turn off the gas at the meter if it is safe to do so, open doors and windows, do not use switches or flames, and call the Gas Emergency number on 0800 111 999. Do not wait for an engineer booking.
How do I choose an engineer?
Check that the engineer is on the Gas Safe Register and look at their ID card. Which? advises asking for the call out charge before they arrive, not including any repair work, and checking reviews away from the firm's own site. Our guide on whether you need a Gas Safe engineer explains how to check the register, and you can find a plumber or heating engineer in Coventry from there.
If you rent, tell your landlord straight away. They are normally responsible for arranging repairs to the boiler and heating.
Can a breakdown be avoided?
Not always, but an annual service helps spot problems early. Our boiler service cost guide explains what is included and what you might pay. If a radiator is cold only at the top, bleeding it is a small job that a handyman can often do. Keep an eye on the pressure gauge in winter.
At a glance
| Problem | Safe to try yourself? | Next step |
|---|---|---|
| No power or blank display | Yes, check fuse board and sockets | Call an electrician or engineer if it persists |
| Thermostat or timer wrong | Yes | Reset settings, replace batteries |
| Prepayment meter out of credit | Yes | Top up |
| Low pressure | Yes, using the filling loop | Engineer if it keeps dropping |
| Reset button outside the casing | Yes, once | Engineer if it keeps tripping |
| Reset inside the casing | No | Gas Safe engineer |
| Smell of gas | No | Call 0800 111 999 at once |
What the pressure gauge is telling you
| Reading | What it usually means | What to do |
|---|---|---|
| Below 1 bar | Pressure too low, the boiler may lock out | Top up with the filling loop as in your manual |
| 1 to 2 bar (green zone) | Normal for most sealed systems | Nothing, check other causes |
| Above the green zone | Pressure too high | Check the manual, call an engineer if it stays high |
| Keeps falling after top ups | Possible leak | Gas Safe engineer |
Numbers to keep to hand
| Item | Number | Note |
|---|---|---|
| Gas Emergency line | 0800 111 999 | Free, 24 hours, call if you smell gas |
| Normal sealed system pressure | 1 to 2 bar | Many UK guides, check your model |
| Single resets before calling an engineer | 1 | Repeated resets mean a fault |
This is general guidance, not legal advice. Rules and prices change, so check the official sources listed below.
Questions
Why has my boiler stopped working?
Common causes include no power, wrong thermostat settings, an empty prepayment meter, low pressure or a lockout. Run through the checks in this guide first.
What should my boiler pressure be?
Many UK guides give 1 to 2 bar for a sealed system. Check the gauge and your manual, because it can vary by model.
Can I fix my boiler myself?
You can do basic checks, such as settings, pressure and a reset. Anything inside the casing is gas work and must be done by a Gas Safe registered engineer.
What do I do if I smell gas?
Open windows and doors, do not use switches or flames, turn off the gas at the meter if safe and call 0800 111 999 straight away.
How do I check an engineer is registered?
Use the Gas Safe Register website and check the engineer's ID card for the types of work they are qualified to do.
Who pays if I rent?
Usually the landlord arranges repairs to the boiler and heating. Tell them promptly and keep a record of when you reported it.
Why is my boiler making a banging or gurgling noise?
It can be trapped air, limescale, low pressure or a failing part. If bleeding the radiators and checking pressure do not stop it, have an engineer look.
Why is there no hot water but the heating works?
It can point to a diverter valve or a hot water setting problem. This is a job for an engineer, not for DIY.
Is it worth repairing an old boiler?
It depends on its age, parts and repair cost. Ask the engineer for a quote and compare it with the cost of servicing and cover, as in our boiler service cost guide.
Can a handyman fix my boiler?
No. Anything on the gas or inside the boiler casing needs a Gas Safe registered engineer. A handyman can help with non gas jobs like shelves and doors.
What if the boiler breaks down on a weekend?
Ask whether the engineer charges extra out of hours and what the call out fee is before they arrive. Which? recommends confirming this first.
Sources
- British Gas, what to do if your central heating stops working
- Corgi HomePlan, how to reset your boiler
- Worcester Bosch, broken boiler support
- Which?, what to do if your boiler breaks down
- Viessmann, boiler broken what to do next
- HomeServe, how to diagnose common boiler problems
Keep reading
- Do you need a Gas Safe engineer?
- How much does a boiler service cost?
- Find a plumber in Coventry
- Plumbers in Foleshill
- Boiler pressure too low: what to do and how to top it up
- Why is my radiator cold at the bottom? Causes and fixes
- What does a plumber charge for a leaking tap in the UK?
- How to stop a dripping tap: washer, O-ring or cartridge
- Find a handyman in Coventry
- How Coventry Home Fix works