Home / Guides / What does a plumber charge for a leaking tap in the UK?

Costs · Published 2026-11-16 · Updated 2026-11-16

What does a plumber charge for a leaking tap in the UK?

A leaking tap is one of the smallest plumbing jobs, but quotes for it vary more than people expect. This guide sets out the published guide ranges for 2026, what pushes the price up or down, and how to check a quote before you agree to it. By the end you will know roughly what a fair bill looks like for your type of tap.

Quick answer. Published 2026 guide ranges put a plumber's fix for a leaking or dripping tap at about £50 to £150, with an average near £100. A simple washer swap sits at the bottom, a mixer tap cartridge in the middle, and a worn valve seat or replacement tap at the top. Out of hours work costs more.

Bar chart of published price ranges for fixing a leaking tap from four guides
Published guide ranges for fixing a leaking tap, 2026

How much does a plumber charge to fix a leaking tap?

The most direct figure comes from Fantastic Services, whose 2026 dripping tap guide (page updated 30 September 2026) gives £50 to £150 including VAT, with an average of £100, outside London. The WaterSafe Register's 2026 plumber cost guide lists a leaking tap at £60 to £120. Checkatrade's June 2026 guide has no tap figure, but it gives £77 to £128 for fixing a general leak, which is a useful cross check. HomeServe's older guide suggests £100 to £150 for a small leak, though it bases its numbers on 2023 and 2024 data, so treat it as the least current.

Put those together and a sensible expectation for one ordinary tap is somewhere between £60 and £130. If a quote lands far outside that, ask what the extra covers. It might be a good reason, such as an old tap that needs replacing, or it might not be.

What does the price depend on?

The type of fault matters most. Fantastic Services splits the work into three bands for the rest of the UK: a washer or O-ring swap at £50 to £70, a cartridge replacement on a mixer tap at £60 to £110, and a complex valve or valve seat repair at £90 to £140. London and the South East run higher, at £60 to £180 overall for the same job.

Beyond the fault itself, the guides agree on a handful of cost drivers. These are worth knowing before you ring anyone.

  • The age and type of tap. Old compression taps often need only a washer, while modern mixer taps usually need a whole cartridge, and a worn tap may not be repairable at all.
  • Whether there is an isolation valve under the sink. Without one, the plumber may have to shut off the water to the whole house, which takes longer.
  • Access. A tap behind a tight basin or a boxed in kitchen sink takes more time than one on an open bath edge.
  • The time of the booking. Evening, weekend and bank holiday work often costs one and a half to two times the normal rate, plus a call-out fee.
  • Whether you supply the new part. Some plumbers will fit a tap you bought, others prefer to supply it, and the labour rate may differ.

What do the parts cost?

Parts are the smallest part of the bill. Fantastic Services lists a tap washer or an O-ring at £1 to £5, a ceramic cartridge at £10 to £30 and a ceramic disc valve at £15 to £40, all including VAT. A full replacement tap runs from £30 to £350, which is a wide spread because it depends on the finish and brand you choose.

That is why a quote of £90 for a washer swap should make you pause. The washer might cost £3, so almost the whole price is the plumber's time and call-out. Time is a fair thing to pay for, but you can ask how long they expect the job to take. If you want to try it yourself first, our guide on how to stop a dripping tap walks through the steps and the tools.

What hourly rate and call-out fee should I expect?

Checkatrade's June 2026 figures put the average plumber's hourly rate at £50, with a range of £40 to £60, and a day rate of £325 to £375. WaterSafe gives £40 to £70 an hour and £250 to £400 a day. HomeServe says £40 to £80 an hour. Checkatrade adds that the minimum charge is usually the cost of one hour's work, so a ten minute washer swap often becomes a one hour bill.

Emergency or out of hours work is higher. Checkatrade gives £75 to £150 an hour for emergencies, averaging £100, and a call-out fee of £100 to £120, averaging £110. WaterSafe's emergency call-out range is £60 to £120. A dripping tap is rarely an emergency, so unless water is pouring out and you cannot stop it, waiting until normal hours usually saves money.

What is a worked example of the total?

The table below uses the Checkatrade average of £50 an hour and the Fantastic Services parts prices, with the midpoint of each parts range. These are worked examples with stated assumptions, not quotes. Real jobs depend on the plumber, the tap and the day.

If you are not sure whether a job is a plumber's or someone else's, our guide to handyman or specialist explains where the line usually sits. Swapping a washer is a plumbing job in most people's eyes, but plenty of general handymen in Coventry do it routinely.

When is a replacement tap better than a repair?

If the tap is old, badly limescaled or the valve seat is scored, a repair may only buy you a few months. Fantastic Services gives £80 to £250 for supplying and fitting a replacement tap, and WaterSafe lists new tap installation at the same £80 to £250. Both figures are worth comparing against a repair price. If a repair already costs £100 and the new tap would be £150, replacing it is often better value.

Check that any new tap is suitable for your water pressure and that the plumber is competent for the work. Our Gas Safe checklist is about gas, not taps, but the habit of checking credentials before work starts is the same. WaterSafe is the register to look at for plumbers who work on water fittings.

How can I check a quote and avoid overpaying?

Get the quote in writing and ask it to state whether VAT is included. Checkatrade notes that a quote should say so if the plumber is VAT registered, and WaterSafe says the same where it applies. Ask whether the figure is a fixed price or an hourly estimate, and whether parts are included.

If the plumber has other small jobs to do in the same visit, such as a toilet that keeps running, ask for them to be priced together. A single visit with a minimum one hour charge covers several small fixes more cheaply than separate trips. You can browse plumbers in Earlsdon or any other area, or start from the main Coventry plumber directory. We list businesses but we do not vet or recommend them, so compare at least two quotes.

Does a leaking tap waste water and money?

Yes, though the amount depends on the drip. HomeServe's guide says a leaking tap can waste nearly 100 litres a day, but that page is promotional, so treat the figure as a rough upper case, not a typical one. If you are on a water meter, a steady drip adds to your bill, and a tap leaking behind a cabinet can damage the unit. Fixing it early is cheaper than repairing water damage.

If water is escaping from a pipe, not from the spout or handle, you may have something more serious than a tap. Our guide to a burst pipe and finding your stop tap covers what to do first. In Coventry the water company is Severn Trent Water, which is the place to ask about metering.

At a glance

FaultTypical published rangeSource
Washer or O-ring swap£50 to £70 (£60 to £95 London and South East)Fantastic Services, 2026
Mixer tap cartridge£60 to £110 (£80 to £130 London and South East)Fantastic Services, 2026
Valve or valve seat repair£90 to £140 (£120 to £150 London and South East)Fantastic Services, 2026
Any leaking tap£60 to £120WaterSafe Register, 2026
Replacement tap, supplied and fitted£80 to £250Fantastic Services and WaterSafe, 2026

Worked examples (assumes £50 an hour, minimum one hour, parts at midpoint)

JobLabourPartsTotal
One tap, washer swap1 hour x £50 = £50Washer £3£53
One mixer tap, new cartridge1 hour x £50 = £50Cartridge £20£70
Two mixer taps, new cartridges1.5 hours x £50 = £752 x £20 = £40£115
Out of hours cartridge swap£110 call-out + 1 hour x £100 = £210Cartridge £20£230

Hourly and call-out figures from published guides

SourceHourly rateCall-out or emergency
Checkatrade, June 2026£40 to £60 (average £50)£100 to £120 (average £110)
WaterSafe Register, 2026£40 to £70£60 to £120
HomeServe, based on 2023 and 2024 data£40 to £80About £100 flat for emergencies

This is general guidance, not legal advice. Rules and prices change, so check the official sources listed below.

Questions

How much does it cost to fix a dripping tap?

Published 2026 guide ranges are about £50 to £150, with an average near £100 outside London. A simple washer swap is the cheapest at £50 to £70.

Is it worth calling a plumber for a leaking tap?

Often yes, if you are not confident, because the minimum charge is usually one hour at about £50. If you can isolate the water, a washer costs £1 to £5, so a DIY fix can be very cheap.

Why is there a minimum charge for a quick job?

Checkatrade says the minimum is usually the cost of an hour's work. It covers travel, setting up and the time lost between bookings.

Does the price include VAT?

It depends. Fantastic Services includes VAT in its tap repair ranges, while other guides do not say. Ask for the quote to state whether VAT is included.

How much does a replacement tap cost to fit?

WaterSafe and Fantastic Services both give £80 to £250 for supplying and fitting a new tap. Fitting only, if you buy the tap yourself, should come in lower.

Will it cost more at the weekend?

Usually. Checkatrade says emergency or weekend work can be up to twice the normal hourly rate plus a call-out fee, with an average emergency rate of £100 an hour.

Can a handyman fix a leaking tap?

Many can fix a simple washer or cartridge job, but check what they are competent and insured for. See our handyman or specialist guide and the handyman directory.

What if the leak is from the pipe under the sink?

Turn off the water at the isolation valve or stop tap and call a plumber. Our burst pipe guide shows how to find your stop tap.

How long does a tap repair take?

A washer or cartridge swap usually takes under an hour once the water is off. Complex valve seat repairs take longer, which is why they sit at the top of the price range.

Is there a cheaper way to get quotes?

Ask two or three firms for written prices and compare them against the ranges above. You can start with the Coventry plumber directory, where we list businesses but do not vet them.

Sources

Keep reading